Any air conditioner is subject to natural wear and tear. Sooner or later, each user may encounter failures in the operation of the split system, and it is important to know what this or that error means. In this article you will find all the main error codes of MDV air conditioners.
An error occurred in the operation of the volatile memory module located in the internal unit of the air conditioner.
There was a failure in the interblock communication.
An error occurred monitoring the transition of the signal through zero.
The indoor unit fan is not controlled.
Failure of the indoor air temperature sensor.
Failure of the boiling point sensor.
there was an error in the display operation on the control board.
There was a leak of the refrigerating agent (freon).
The air temperature sensor failed in the outdoor unit.
The condensation sensor failed in the outdoor unit.
The pressure sensor failed in the outdoor unit.
An error occurred in the operation of the volatile memory module located in the outdoor unit of the air conditioner.
The fan of the outdoor unit is not controlled.
There was a failure in the IPM module.
Insufficient or excessive supply voltage is detected.
The compressor overheated.
A fault was detected in the inverter module.
In this article, we talked about the main errors that occur in the operation of the split system from the MDV brand. If your air conditioner signals a malfunction, call a specialist or service center and report the problem. Do not try to repair the air conditioner yourself if you do not have practical experience. Good luck!