I FEEL button in the air conditioner

How to turn on and configure the Daikin air conditioner?

How to turn on and quickly set up the air conditioner from the company Daikin, if there were no instructions at hand? Read our short but very useful article.

Quickly enable and configure

instructions for the air conditioner

With remote control

Here we will not explain in detail what each button means. Instead, we will give you a simple and clear guide to quickly set up the device. After spending a few minutes, you can enjoy the long-awaited coolness or warmth, depending on the time of year.

Start:

  1. Turn the air conditioner on, point the remote control at it, and press the «ON/OFF» button. You will know that the unit has turned on when you hear a distinctive beep and see the green LED on the air conditioner housing;

  2. Press the «MODE» button sequentially until you select the optimal operating mode. On the display of the remote control, you will see the name of the selected mode: AUTO, COOL, DRY, HEAT, FAN.

  3. Press the up and down buttons to set the desired temperature. In AUTO mode, the temperature is set to 25 degrees;

  4. If you are in ventilation mode, adjust the fan speed by pressing the » FAN » button. Press sequentially until you select the optimal mode. The button works on the same principle as MODE;

  5. Adjust the air flow direction by pressing the «SWING» button. After clicking, the guides will start moving. After pressing again, they will lock in their position.

Without remote control

The air conditioner can be turned on in the so-called emergency mode, without a remote control. We do not recommend using this method on a daily basis, but it will save you if the remote control suddenly breaks down on a hot summer day. Follow the simple instructions:

  1. First, you need to remove the decorative panel from the wall housing of the air conditioner. It is attached to the latches located around the perimeter of the block. Carefully snap them off and remove the panel. You will probably be surprised how much dust is inside the air conditioner, so you can also clean and disinfect;

  2. In the lower right part of the case, find a small button. It is usually recessed inwards, and a thin, hard object is needed to push it. This is the emergency power button;

  3. Press the button 1 time and wait for 10-15 minutes to feel which mode is currently on. Different models of air conditioners are configured differently. Usually, after the first press, the automatic mode is turned on, when the device itself selects the temperature and other parameters. In some models, the cooling mode is immediately turned on, and when you press the button again, the air conditioner simply turns off. And in some devices, the button works sequentially, as well as» MODE » on the remote control. Experiment a little to adjust the device to meet your expectations.

We hope this article was useful for you. In the comments below, you can share your tips and recommendations on how to turn on the air conditioner from the brand Daikin. Good luck!

Добавить комментарий

Ваш адрес email не будет опубликован. Обязательные поля помечены *